Safety Information

About this manual

Read carefully this chapter to raise your awareness of potential risks and hazards when working with the Nix Servo Drive.

To ensure maximum safety in operating the Nix Servo Drive, it is essential to follow the procedures included in this guide. This information is provided to protect users and their working area when using the Nix Servo Drive, as well as other hardware that may be connected to it. Please read this chapter carefully before starting the installation process. Please also make sure all system components are properly grounded.

Warnings

The following statements should be considered to avoid serious injury to those individuals performing the procedures and/or damage to the equipment: 

  • To prevent the formation of electric arcs, as well as dangers to personnel and electrical contacts, never connect/disconnect the Nix Servo Drive while the power supply is on.
  • Disconnect the Nix Servo Drive from all power sources before proceeding with any possible wiring change.
  • After turning off the power and disconnecting the equipment power source, wait at least 10 seconds before touching any parts of the controller that are electrically charged or hot.

Precautions

The following statements should be considered to avoid serious injury to those individuals performing the procedures and/or damage to the equipment:

  • The Nix Servo Drive components temperature may exceed 100 ÂșC during operation.
  • Some components become electrically charged during and after operation. Expect voltages > 100 V that could be lethal.
  • The power supply connected to this controller should comply with the parameters specified in this document.
  • When connecting the Nix Servo Drive to an approved power source, do so through a line that is separate from any possible dangerous voltages, using the necessary insulation in accordance with safety standards.
  • High-performance motion control equipment can move rapidly with very high forces. Unexpected motion may occur especially during product commissioning. Keep clear of any operational machinery and never touch them while they are working.
  • Do not make any connections to any internal circuitry. Only connections to designated connectors are allowed.
  • All service and maintenance must be performed by qualified personnel.
  • Before turning on the Nix Servo Drive, check that all safety precautions have been followed, as well as the installation procedures.